Recorded message will play (LED turns OFF) Adjust Volume Press # then press 3 or 6 to raise or lower volume Phone Test 1. Press 1 to end (LED begins FLASHING) Play 1. Keypad will return to original partition in 2 minutes or with User Code + * + 0 User MUST be assigned for multiple partition access in User Codes section Voice Keypads Voice Chime # to Enable or Disable (Keypad should say "ON" or "OFF") Show Status # * Show Faults Press * * Record Message 1. Enter Partition 0 = Return to original Partition 1 = Partition 1 2 = Partition 2 3 = Common Lobby Partition 3. 1 Zones 64 total Ademco Vista-20P/First Alert FA-168C Basic Commands Wireless Yes, Zones 09 to Keyfob Zones (Zones 49 to 64) Batteries Downloadable Partitions 2 12 volt Rechargable inside main Panel, AC Transformer 16 volts Door/Windows 3-Volt Lithium Motion Sensor 2 3-Volt Lithium Smoke Detector 2 9-volt Alkalines Remote Keypads 3-Volt Lithium Keyfobs 3-Volt Lithium Remote Panics 9-Volt Lithium Yes Panic Buttons Police Panic - * and # Fire Panic - 1 and * Medical Panic - 3 and # Status Arm Away Arm Stay Instant Arm Max Arming Quick-Arm Disarm Silence Alarm Bypass Press * if keypad shows NOT READY to view open zones 4-digit code + 2 (AWAY) to arm everything 4-digit code + 3 (STAY) to arm all but motions 4-digit code + 7 (INSTANT), this also bypasses motions 4-digit code + 4 (MAX) and everything arms instant # + 2 for AWAY, # + 3 for STAY 4 digit code + 1 (OFF) 4-digit code + 1 (OFF) twice to turn off siren and reset display (If code is entered wrong, wait 2 or 3 seconds then try again) 4-digit code + 6 (BYPASS) + zone (01, etc) (keypad will beep, BYPASS + Zone should show, arm system) Quick Bypass User Code # (Bypasses all open Zones) Alarm Memory Reset Smoke Door Chimes See Event Buffer 4-digit code + 1 (OFF) twice to turn off siren and reset smoke (If this does NOT reset smoke detector set for service, smoke is bad) 4-digit code + 9 (CHIME) GoTo Partition 1.
0 kommentar(er)
